Introduction
Galvanised trunking is a popular choice for organising and protecting electrical cables in various settings. Its durability and corrosion resistance make it an ideal solution for both residential and commercial installations.
If you're considering installing galvanised trunking, this step-by-step guide will walk you through the process and help you achieve a successful installation.
Gather the Necessary Tools and Materials
Before you begin the installation, make sure you have all the required tools and materials. These typically include:
Galvanised trunking sections
Trunking accessories (elbows, tees, connectors)
Measuring tape
Pencil or marker
Hacksaw or pipe cutter
Drill
Screws
Screwdriver
Spirit level
Safety equipment (gloves, goggles)
Plan the Trunking Layout
Start by planning the layout of the trunking system. Consider the location of power sources, electrical outlets, and the path you want the trunking to follow. Measure the distances and use a pencil or marker to mark the positions where the trunking will be installed.
Cut the Trunking Sections
Using a hacksaw or pipe cutter, cut the galvanised trunking sections to the required lengths. Make precise cuts to ensure a neat and secure installation. Remember to wear safety gloves and goggles during this step to protect yourself from sharp edges.
Install the Trunking
Begin by positioning the first trunking section against the wall or surface where it will be installed. Use a spirit level to ensure it is perfectly level. Mark the positions for screw holes with a pencil or marker. Then, using a drill, create holes for the screws at the marked spots.
Next, align the trunking section with the holes and insert screws through the holes into the wall or surface. Tighten the screws securely but be careful not to overtighten and damage the trunking. Repeat this process for each trunking section, ensuring they are properly aligned and level.
Add Trunking Accessories
To navigate corners or changes in direction, you may need to use trunking accessories such as elbows, tees, or connectors. These accessories allow the trunking to maintain a clean and organised appearance while accommodating changes in cable routing.
Measure and mark the positions where the accessories will be installed and cut the trunking sections accordingly. Attach the accessories by sliding them into the trunking sections and securing them with screws or clips.
Connect Trunking Sections
When you reach the end of one trunking section, you will need to connect it to the next section to continue the cable pathway. Use a connector specifically designed for galvanised trunking to join the sections securely. Follow the manufacturer's guidelines for proper installation of the connectors.
Install Cover Plates
Once all the trunking sections are in place, install the cover plates. These plates help protect the cables and give the installation a finished appearance. Align the cover plates with the trunking sections and secure them using the provided screws or clips.
Test the Installation
After completing the installation, it is essential to test the trunking system. Ensure that all cables are securely housed within the trunking and that the cover plates are properly fastened. Test the electrical connections to verify that power is flowing correctly and that there are no issues or disruptions.
Conclusion
Installing galvanised trunking is a straightforward process that can significantly improve the organisation and protection of your electrical cables. By following this step-by-step guide, you can successfully install galvanised trunking in a variety of settings.
Remember to always prioritise safety by wearing appropriate protective gear and following manufacturer's instructions when necessary.
If you want to take a closer look at our range of galvanised trunking click here.
Related Products
